3DPS - 3D nyomtatás és fejlesztés

Services

Repair & build

General troubleshooting, repair, assembly and custom build work.

Consulting

Part selection, upgrade direction, preventive maintenance and operational guidance.

Testing

Print, electronic and mechanical validation, firmware testing and fault reproduction.

Engineering support

Support for custom projects, prototype refinement and technical collaboration.

News

Articles from this month

2026. 07. 27.

Anycubic Kobra 3 toolhead – successful firmware backup and the first steps toward a CAN-based Klipper toolboard

Anycubic Kobra 3 Toolhead Project – Another Milestone: Successful Firmware Backup and Preparing for a CAN-Based Toolboard Today marked another major milestone in the Anycubic Kobra 3 Toolhead project. Our objective is not to modify or preserve the original firmware. Instead, we are developing a completely custom firmware that will transform the factory controller board into a Klipper-compatible CAN Tool MCU with only minimal hardware modifications.

2026. 07. 26.

Another Milestone Reached in the Anycubic Kobra 3 Toolhead Project #2

Another Milestone Reached in the Anycubic Kobra 3 Toolhead Project The Anycubic Kobra 3 Toolhead reverse engineering project has reached another important milestone. Recent work has shifted beyond simply identifying components toward building a comprehensive and structured hardware documentation system that will serve as the foundation for all future development.

2026. 07. 26.

Anycubic Kobra 3 Toolhead Project – First Hardware Documentation Milestone Completed

Anycubic Kobra 3 Toolhead Project – First Hardware Documentation Milestone Completed The reverse engineering project has reached another important milestone. Our recent work has focused not only on identifying individual components but also on building a structured hardware documentation system that will serve as the foundation for mapping the entire electronics assembly.

2026. 07. 24.

New Project at 3DPS – Anycubic Kobra 3 Toolhead Reverse Engineering

A new long-term development project has officially started at the 3DPS workshop. The goal is to perform a complete reverse engineering of the original Anycubic Kobra 3 toolhead electronics.

Earlier articles